| |
 |
|
The Security System For Network And Server Racks
System and network management
requirements mean the systems’
ambient conditions must be monitored.
Reliability and system availability
are indispensable.
Compliance with the required ambient
parameters is extremely important
for the fault-free operation
of high-grade components.
Inadmissible fluctuations in temperature
or air humidity often cause
hardware defects. Constant automatic monitoring
of these parameters
is therefore a basic
requirement for ensuring properly
functioning operability.
With the rack monitoring systems
offered by Knürr,
this information
can be recorded and forwarded directly
to a higher-level management
system.
This recording is not, however, sufficient
to ward off damages. For
short response |
|
times when faults
occur, it is helpful if the monitoring
system can perform actions automatically
(e.g. activate additional
fans).
When defined incidents occur,
Knürr RMS Compact II® can immediately
send a message as an
“SNMP trap” to the management
system or
directly as an e-mail
to a technician or an
SMS gateway.
Rapid error finding and removal is
valuable! The ability to connect additional
sensors to monitoring systems
not only allows racks to be
monitored – so too can complete
rooms or building sections. All important
environmental parameters
of a system can consequently be
recorded and evaluated in an easy
and straightforward way. |
|
The advantages of Knürr’s
modern rack monitoring system:
• Guarantees fault-free operation
• Detects disturbances early
• Logs incidents
• Makes service assignments easier
with automatic monitoring
• Activates countermeasures in the event of a fault
• Central control of consumables
(filters, paper, toner, meter readings,
inspection intervals, etc.)
• Connection of up to 12 sensors
in any arrangement |
|
Technical Data:
• Compact structure - Zero Unit Solution (installed outside 19"-installation area)
• 19" installation with an adapter angle
• Safe fixture of all connected cables by means of an integrated cable cleat
• Cost-effective, clean installation using Plug & Play concept
• Comfort cabling through the connection of RJ45 sensors
• TCP/IP connection via Ethernet (10/100 Base T)
• Configuration through SNMP and Web Browser
• Access to Web is protected by password and is optionally coded (https)
• 3 different user levels
• Freely programmable system of filters (Boolean Logic) for implementing
various alarm conditions
• Compatible with common network control systems - HPOpenView, Cabletron
Spectrum, Castlerock, IBM Netview, IBM Tivoli, MG-Soft, Compaq Insight Manager,
SUN NetManager, etc.
• Sensors for the control of all common influences of the environment (optional)
• Internal voltage source (no additional power source is required)
• Alarm through LED, relay, network device or e-mail (SMTP)
• Syslog support for continuous external storage of data
• Comparing system time with NTP servers
Dimension
• Length, 280 mm
• Width, 140 mm
• Height, 40 mm
Approvals
• CE Label in accordance with low voltage guidelines, 73/23/EWG,
EMC guideline 89/336/EWG
|
|
 |
|
|
|
|
|
|
back
Print page
top